How Should Oily Wastewater from Cogeneration Projects Be Treated? What New Technologies Are Available?
In cogeneration projects, the treatment of oily wastewater is a key step towards environmental compliance. Such wastewater usually comes from lubricating oil leakage from equipment, the treatment of fuel combustion off-gas and pipeline flushing, and contains emulsified oil, suspended solids and organic pollutants; discharged directly, it would seriously pollute water bodies. Conventional treatment methods suffer from low efficiency, high cost and the risk of secondary pollution.
The oily wastewater generated by cogeneration projects has the following characteristics:
Complex oil composition: it contains free oil, dispersed oil, emulsified oil and dissolved oil, and conventional gravity separation can hardly remove the emulsified oil completely;
Large water quality fluctuations: both the flow rate and the pollutant concentrations vary with the production load, which demands a highly adaptable treatment process;
Strict environmental standards: the oil concentration must meet the limit of no more than 5 mg/L set by the Integrated Wastewater Discharge Standard.
To solve the wastewater treatment challenge in cogeneration projects, SINOKLE developed a treatment process built around the KHC coalescing pressure
deoiler as the core unit. After practice on several projects, the treated effluent has been tested and consistently meets the standard, achieving the expected treatment performance and effectively solving the oily wastewater problem at this cogeneration project.
The process combines a customised filter with a high-efficiency coalescing pressure deoiler: the oily wastewater first passes through the filter to remove suspended solids and residue, and then enters the high-efficiency deoiler for oil-water separation. The effluent is clear and bright and meets the national discharge standard.

Oily wastewater treatment unit for the cogeneration project
As the core patented technology, the high-efficiency coalescing pressure deoiler is based on the coalescence principle and shallow-pool theory and uses CFD numerical simulation to optimise the tank space and structure systematically. By scientifically planning the internal flow field, it achieves efficient aggregation, coalescence, flotation (or settling) and separation of oil droplets and suspended solids in the aqueous phase. The equipment adopts a three-stage separation architecture: a cyclone separation device in the inlet pre-separation zone, gradient coalescing packing in the primary and main separation zones, an integrated oil collection unit at the top and an intelligent sand-washing and sludge-removal system at the bottom, forming a complete separation chain.

Inlet and outlet comparison (left: influent; right: effluent)
This technology system offers four core advantages:
Integrated design: the compact structure saves 60% of floor space and oil removal efficiency exceeds the 90% technical threshold;
Material innovation: the patented coalescing packing uses high-strength stainless steel or reinforced polypropylene, combining excellent mechanical properties with durability;
Anti-clogging assurance: a proprietary vortex sand-washing device performs dynamic desilting, keeping the open ratio of the packing layer above 95% over the long term;
Intelligent operation: fully enclosed pressure-type automatic control with zero leakage risk in operation; safety and environmental indicators meet national standards.
Verified in engineering projects covering refining wastewater and power-plant circulating water, the process shows outstanding stability and adaptability: under continuous operation for more than 8,000 hours the oil content of the effluent remains within the standard. Its technical universality now covers oily wastewater treatment in the energy, chemical and power industries, making it a benchmark in industrial water treatment.