Treatment of RO Concentrate from Refinery Wastewater with CDOF Ozone Catalytic Oxidation
The RO Concentrate Problem in Refinery Water Reuse
At home and abroad, reverse osmosis (RO) concentrate is handled by increasing recovery rate, direct or indirect discharge, comprehensive utilization, or evaporation concentration. Raising the recovery rate and direct or indirect discharge do not fundamentally remove the pollutants; comprehensive utilization has major limitations for wastewater with complex pollutant composition; and evaporation concentration consumes so much energy that most enterprises cannot bear the cost. Finding a treatment method that efficiently degrades the pollutants is therefore the key to solving the RO concentrate problem.
The dual-membrane process is widely used for advanced treatment and reuse of industrial wastewater because of its simple flow, easy operation and small footprint. However, while the RO stage produces clean reusable water, it also generates concentrate with much higher pollutant concentrations - usually one third of the reclaimed water volume - and this concentrate's COD generally exceeds discharge standards, so it cannot be discharged directly. In refinery wastewater reuse projects, RO concentrate typically has a COD of about 200 mg/L, oil of about 10 mg/L and TDS of 5,000 mg/L or more, with a low B/C ratio, making it extremely difficult to treat. RO concentrate treatment has therefore become the bottleneck of the dual-membrane process in wastewater reuse.
CDOF: Ozone Advanced Catalytic Oxidation
Ozone has strong oxidizing power and decomposes refractory organics well, but a pure ozone oxidation process suffers from low ozone utilization. To raise utilization and oxidation efficiency, a catalytic approach can be adopted. Combining its self-developed products, SINOKLE can effectively reduce wastewater COD and improve biodegradability, favoring the subsequent biological reactions.

Ozone advanced catalytic oxidation process flow diagram
The process shown above is CDOF (Cyclonic Dissolved Ozone Flotation), a technology independently developed by SINOKLE. CDOF creatively combines ozone advanced oxidation, cyclonic separation and dissolved-air flotation to achieve efficient, comprehensive removal of various hard-to-treat wastewaters.
The ozone catalytic oxidation process has a short flow, simple equipment and compact, small treatment units with a small footprint; it uses few electrical devices, consumes little power and has low operating costs; it is easy to operate and can be automatically controlled, simplifying on-site operation. When flow and water quality change, flow and quality can be adjusted, giving strong adaptability and shock-load resistance. It can also be combined with other technologies (such as biological treatment) to bring out the strengths of each and further improve treatment results.
Micro-Nano Bubbles

The ultra-fine micro-nano bubble generation technology centers on high-efficiency dissolution, release and mixing equipment - the micro-nano bubble generation system. Micro-nano bubbles are extremely fine bubbles with diameters below 50 µm. They rise slowly, stay in the water longer and dissolve with high efficiency, and they also possess self-oxygenating, negatively charged, and free-radical-rich properties with strong oxidizing power.
Laboratory Test on a Company's RO Concentrate



Test conclusion: at an ozone dosage of 300 mg/L, the effluent COD was 89.55 mg/L, with 492.45 mg/L of COD removed and an ozone-to-COD ratio of 0.61 - demonstrating a significant removal effect on COD.