New Process for RO Concentrate Treatment in Thermal Power Plants

2026-11-20 10:47:28
立即下载


RO concentrate from a thermal power plant is the concentrated wastewater produced after reverse osmosis (RO) membrane treatment in the plant's water treatment system. It contains high concentrations of salts, dissolved solids and organic matter, and its high salinity and organic load make it difficult to treat. The key points are as follows:

Source: mainly the boiler make-up water treatment system. In RO treatment about 75% of the water becomes reusable permeate and the remaining 25% or so forms high-salinity concentrate.

Characteristics: high salt content, plus heavy metal ions and organic pollutants, with a strong tendency to scale and corrode; direct discharge would seriously harm the environment.


Common treatment methods:

Nanofiltration: two-stage nanofiltration in series purifies sodium chloride; the permeate can be used to prepare regeneration solution, while high-calcium concentrate is treated in a crystallisation pond to remove calcium sulphate and convert the acid.

Electrodialysis (ED): the electric field efficiently concentrates the wastewater, raising the salt mass fraction above 20% and water recovery above 90%, which lowers the cost of zero liquid discharge.

Evaporative concentration and crystallisation: low-temperature evaporation efficiently concentrates the wastewater, reduces its volume, saves energy, achieves zero liquid discharge and recovers salt resources.


Integrated treatment process

Pre-treatment + membrane technology + evaporative crystallisation: pre-treatment removes suspended solids and hardness, membrane technology concentrates the water further, and evaporative crystallisation finally recovers salts and achieves zero liquid discharge.

Challenges: high salinity and high organic content, high treatment cost, complex technology, and a strong tendency to membrane fouling and scaling.

Outlook: as technology advances, new membrane materials and processes will raise efficiency, lower costs, enable resource recovery and support the sustainable development of thermal power plants.


To treat RO concentrate carrying high concentrations of salts, dissolved solids and organic matter, SINOKLE has proposed a new process based on its independently developed products.

sinokle 

Process flow diagram

The process shown is SINOKLE's independently developed technology CDOF (advanced ozone catalytic oxidation), CDOF (Cyclonic Dissolved Ozone Flotation Unit), which creatively combines advanced ozone oxidation, cyclonic technology and dissolved gas flotation to achieve efficient, comprehensive removal of pollutants from a wide range of hard-to-treat wastewaters.

Ozone catalytic oxidation has a short flow, simple equipment, small compact treatment units, a small footprint, few electrical devices, low power consumption, low operating cost, and convenient operation with automatic control that simplifies on-site requirements. When water quantity and quality change, the process can be adjusted accordingly, giving strong adaptability and shock load tolerance. It can also be combined with other technologies (such as biological treatment) to exploit their respective strengths and further improve treatment performance.

sinokle 

Micro/nano bubbles


Ultrafine nano-bubble generation: a micro/nano bubble generation system built around efficient gas dissolution, release and mixing equipment. Micro/nano bubbles are extremely fine bubbles smaller than 50 μm in diameter; they rise slowly in water, stay for a long time and dissolve efficiently, and they self-oxygenate, carry negative charges and are rich in strongly oxidising free radicals.


Laboratory treatment of a concentrate

sinokle 

Left: raw water; right: CDOF treated effluent

Experimental data

sinokle 

Experimental conclusion

With this process, at an ozone dose of 500 mg/L, COD is 89.55 mg/L and the COD removed is 410.45 mg/L, indicating highly effective COD treatment, with an ozone dosing ratio of 1.21.

 



Mobile phone/Whatsapp

+86 18926412206

Email

marketing@sinokle.com

Address

Room 2301, Building 1B, Smart Home, Baolong Street, Longgang District, Shenzhen, China

Phone
E-mail
Map
QQ Service