Synthetic Ammonia Compressor Wastewater: Pollution Sources and the CDFU + CDOF Treatment Solution
Synthetic Ammonia in China's Coal Chemical Industry
Synthetic ammonia occupies a central position in coal chemistry. Ammonia is one of the most important basic chemical products - its output ranks first among all chemicals - yet its production is also energy-intensive: roughly 10% of the world's energy is used to synthesize ammonia. About 70% of ammonia goes into nitrogen fertilizers (other nitrogen fertilizers are made by first synthesizing ammonia and then processing it into urea or ammonium salts), known as "fertilizer ammonia"; the remaining 30%, "industrial ammonia," serves as a basic raw material for producing ammonium and amine compounds, dyes, explosives, pharmaceuticals, synthetic fibers and synthetic resins.
Three Pollution Sources in Synthetic Ammonia Plants
Ammonia evaporator blowdown. In the synthesis loop, the ammonia evaporator converts liquid ammonia to gaseous ammonia. Drains must be blown down periodically as process conditions change; the blowdown carries not only accumulated oil and water pollutants but also a large amount of liquid ammonia, which enters the plant's sanitary sewer network and is a major cause of ammonia-nitrogen exceedance in the wastewater.
Recycle-gas compressor oil-water discharge. The compressed gas in the recycle compressor contains ammonia, and a small amount dissolves into the oil-water mixture discharged during separation; this stream also goes straight to the sewer and contributes to ammonia-nitrogen exceedance.
Coke-oven-gas and nitrogen-hydrogen compressor blowdown. During normal production these compressors discharge oil-water separated from process gas every hour, containing process condensate, impurities and cylinder/packing lubricating oil. All of it is discharged untreated into the clean stormwater sewer, the main cause of oil exceedance; oil leakage during operation and non-standard discharge during maintenance aggravate the problem.
SINOKLE's CDFU + CDOF Treatment Solution
To treat the waste liquid generated by synthetic ammonia compressors, SINOKLE combines two independently developed processes - CDFU and CDOF - to bring the effluent up to process standards.

CDFU process flow
CDFU (Cyclonic Dissolved Gas Flotation Unit) is a compact cyclonic dissolved-air flotation unit that effectively integrates centrifugal separation, dissolved-gas flotation and ultrafine bubble generation into a single hybrid device for highly efficient separation of oily, suspended-solids-laden wastewater.
CDFU technology comparison:

CDOF (Cyclonic Dissolved Ozone Flotation unit) is SINOKLE's independently developed ozone advanced catalytic oxidation process. It creatively combines ozone advanced oxidation, cyclonic separation and dissolved-gas flotation to remove stubborn pollutants from difficult-to-treat wastewater with high efficiency.

CDOF process flow
The ozone catalytic oxidation process has a short flow path and simple equipment: treatment units are small and compact, the footprint is small, few electrical consumers keep power consumption low, operating cost is low, and operation is convenient and automatic, simplifying on-site operation requirements. When flow or water quality changes, the system adjusts flexibly with strong shock-load resistance. It can be combined with other technologies such as biological treatment to exploit the advantages of each and further improve removal performance.

Micro-nano bubble generation
Ultrafine micro-nano bubble technology. The core of the system is a micro-nano bubble generation train built around efficient gas dissolution, release and mixing. Micro-nano bubbles are extremely fine bubbles smaller than 50 μm in diameter; they rise slowly, stay in the water longer and dissolve with high efficiency, and they possess self-pressurizing oxygen transfer, negative surface charge and abundant strongly oxidizing free radicals.
Laboratory Verification
Laboratory tests were performed on the compressor wastewater of a synthetic ammonia plant:


Conclusion. With this process, at an ozone dosage of 836 mg/L the effluent COD was reduced to 149.25 mg/L - a COD removal of 186.55 mg/L, corresponding to an ozone-to-COD dosing ratio of 0.43.