What Is Hydrogen Peroxide? Properties, Reaction Chemistry and Industrial Applications of H2O2

2026-11-18 13:10:21
立即下载

Discovery of Hydrogen Peroxide

In 1818 the French chemist Louis Jacques Thenard (1777-1857) prepared barium peroxide by contacting oxygen with red-hot barium oxide:

2BaO + O2 → 2BaO2

After acidification and precipitation purification, barium peroxide yielded an "oxygen-rich" product - an aqueous solution of hydrogen peroxide - and nearly anhydrous pure H2O2 was finally obtained by vacuum distillation.

Physical Properties

At ambient temperature and pressure, hydrogen peroxide is a colorless, transparent liquid with a slightly pungent odor; pure H2O2 is a pale blue viscous liquid. Its density is 1.465 g/cm³ at 0 °C and 1.71 g/cm³ at its freezing point, decreasing as temperature rises. By the like-dissolves-like rule, H2O2 dissolves in polar substances such as alcohols and ethers but is hardly soluble in non-polar solvents such as benzene and petroleum ether, and it mixes with water in any proportion. The aqueous solution is commonly known as hydrogen peroxide solution (perhydrol); commercial concentrations are typically 30% and 3% by mass. The melting and boiling points of pure hydrogen peroxide change with its molecular association: its degree of association is higher than that of water, giving it a higher dielectric constant and boiling point.

Chemical Stability and Oxidizing Power

The oxygen in the peroxide bond has an oxidation state of -1, and the lone-pair electrons on the two oxygen atoms sit close together, creating strong repulsion. Hydrogen peroxide is therefore unstable and a strong oxidizer (the basis of oxidative bleaching). It is most stable in weakly acidic solution (pH 3.5-4.5), decomposes readily in alkaline solution, and also decomposes under strong light, especially short-wave radiation.

H2O2 forms explosive mixtures with many organics such as sugar, starch, alcohols and petroleum products, which can detonate under impact, heat or electrical spark. Although hydrogen peroxide itself is non-flammable, it reacts with combustibles releasing large amounts of heat and oxygen, causing fires and explosions. It decomposes rapidly to oxygen and water in the presence of light, heat (slow at room temperature, explosive decomposition above 153 °C), certain metal salts (e.g. FeCl3), metal oxides (e.g. MnO2) or rough active surfaces. Contact with many inorganic compounds or impurities causes rapid decomposition and explosion, releasing heat, oxygen and steam. Most heavy metals (iron, copper, silver, lead, mercury, zinc, cobalt, nickel, chromium, manganese, etc.), their oxides and salts are active catalysts, and dust, tobacco ash, carbon powder and rust also accelerate decomposition.

Oxidizing Reactions

In acidic media (usually acidified with H2SO4 or HCl), the oxidizing power of hydrogen peroxide is more pronounced than in alkaline media and it acts as a strong oxidant: the oxygen of the peroxide bond gains electrons and is reduced to the more stable -2 state (H2O). Typical reactions with the common reductants ferrous chloride, potassium iodide and lead sulfide (insoluble in water):

H2O2 + 2I- + 2H+ → I2 + 2H2O

H2O2 + 2Fe2+ + 2H+ → 2Fe3+ + 2H2O

4H2O2 + PbS → PbSO4 + 4H2O

Lead sulfide is black while lead sulfate is white - which is why H2O2 is used to clean oil paintings and aged furniture and to bleach paper.

Reducing Behavior

Because the oxygen in the peroxide bond (-1) lies between -2 (lowest) and 0 (highest), hydrogen peroxide behaves as a reductant when it meets an even stronger oxidant, being itself oxidized to O2. Examples with potassium permanganate and chlorine:

2KMnO4 + 5H2O2 + 3H2SO4 → 2MnSO4 + K2SO4 + 5O2↑ + 8H2O

H2O2 + Cl2 → 2HCl + O2

Acid-Base Behavior

H2O2 ↔ H+ + HO2-, Ka1 = 2.3×10-12

HO2- ↔ H+ + O22-, Ka2 = 10-25

H2O2 + 2NaOH → Na2O2 + 2H2O

Sodium peroxide can therefore be regarded, to some extent, as the salt of hydrogen peroxide.

Role as a Reactive Oxygen Species

Hydrogen peroxide is not only an important reactive oxygen species but also the hub through which ROS interconvert. On one hand, H2O2 can directly or indirectly oxidize nucleic acids, proteins and other biological macromolecules and damage cell membranes, accelerating cell aging and breakdown; on the other hand, it is a key regulator in many oxidative stress responses.

Industrial Production Routes

Electrolysis of ammonium sulfate:

2(NH4)2SO4 + 2H+ → (NH4)2S2O8 + 2NH4+ + H2↑

(NH4)2S2O8 + 2H2O → 2NH4HSO4 + H2O2

Although simple, the process consumes much energy and has low unit productivity, so it never reached large-scale industrial production and was replaced by the anthraquinone process.

Isopropanol oxidation: CH3CH(OH)CH3 + O2 → CH3COCH3 + H2O2. The route needs no catalyst, but the by-product acetone must find a market and large quantities of isopropanol are consumed, so it lacks competitiveness and has been phased out.

Direct synthesis from H2 and O2: H2 + O2 → H2O2, but the competing reaction 2H2 + O2 → 2H2O dominates, and the product H2O2 is further reduced (H2 + H2O2 → 2H2O) or decomposed (2H2O2 → O2 + 2H2O). Because the achievable H2O2 concentration is low, this method remains limited.

Anthraquinone process (dominant route): in the working solution, hydrogen is absorbed onto 2-ethylanthraquinone (EAQ) to form 2-ethylanthrahydroquinone (EAQH2), which is oxidized by oxygen to regenerate EAQ and release H2O2; the hydrogenation and oxidation steps are cyclic. Side reactions during hydrogenation produce tetrahydro-2-ethylanthrahydroquinone (H4EAQH2) and tetrahydro-2-ethylanthraquinone (H4EAQ); further hydrogenolysis of H4EAQ generates tetrahydro-2-ethylhydroxyanthrone and tetrahydro-2-ethylanthrone, while oxidation of anthrahydroquinones forms tetrahydro- and hexahydro-2-ethylanthrone epoxides, which must be controlled and purged.

Applications

  • Medical and daily disinfection. Compared with many disinfectants, dilute hydrogen peroxide is mildly irritating and kills bacteria, removes odor and dirt and stops bleeding, which is why 3% perhydrol is a household staple.

  • Laboratory oxygen generation. Because H2O2 decomposes easily, oxygen is generated in the laboratory by adding MnO2 catalyst to hydrogen peroxide solution, collected by upward displacement of air or over water.

  • Forensics and biology. Living cells contain catalase that decomposes hydrogen peroxide, which forensic scientists use to estimate time of death. Luminol, the blood-detection reagent, glows only after treatment with an oxidant - typically a mixture of hydrogen peroxide and a hydroxide base.

  • Bleaching. Industrially, hydrogen peroxide bleaches cotton, raw silk, wool, fur, feathers, hair, bone, ivory, fats, pulp and even gravestones.

  • Restoring furniture. Wiping with an appropriate H2O2 solution restores the original color of furniture: the -2 sulfur in sulfide deposits is a good reductant and reacts with H2O2, removing the precipitate. Lead carbonate pigments (2PbCO3·Pb(OH)2) in old paints react over time with H2S in the air to form black PbS on the surface, dulling the finish.

  • Chemical synthesis. H2O2 is used to make pesticide 401 and the fungicide thiram (C6H12N2S4), and to oxidize olefins to epoxides - ethylene oxidation, H2C=CH2 + H2O2 → CH2OCH2 + H2O, has become an important industrial route to ethylene oxide - and to produce peracetic acid (CH3COOH + H2O2 → CH3COOOH + H2O).

  • Inorganic peroxides. Sodium perborate (NaBO3) and sodium percarbonate (2Na2CO3·3H2O2) are made from hydrogen peroxide, e.g. NaBO2 + H2O2 + 3H2O → NaBO3·4H2O.

  • Electroplating. H2O2 removes inorganic salts and iron from plating baths, improving purity and deposit quality: 2Fe2+ + H2O2 + 2H+ → 2Fe3+ + 2H2O, followed by Fe3+ + 3OH- → Fe(OH)3↓.

  • Propellants. High-purity H2O2 above 90% can serve as fuel and oxidizer: in World War II the German military powered the V-1 and V-2 rockets with hydrogen peroxide, and after the war it continued to be used as a high-energy oxidizer and monopropellant in rocketry.

Safety, Storage and Transport

If hydrogen peroxide touches skin or splashes into eyes, rinse immediately with plenty of warm water. Storage areas should be equipped with spill-response equipment and suitable containment materials. During transport it must be shipped separately; containers must not leak, topple, fall or be damaged. Mixing with acids, flammables, organics, reducers, pyrophoric substances or water-reactive flammables is strictly forbidden. Vehicles should not overspeed or force overtaking and must follow the designated routes; before and after loading, vehicles must be thoroughly cleaned to prevent contamination with organics or flammable impurities.

Relevant Standards (China)

  • GB/T 1616-2014 (replacing GB 1616-2003): Hydrogen peroxide for industrial use

  • GB 22216-2008: Food additive - Hydrogen peroxide

  • GB/T 6684-2002: Chemical reagent - 30% hydrogen peroxide

  • HG/T 5553-2019: Hydrogen peroxide for soil remediation (with titanium dioxide for papermaking, high-purity strontium chloride and high-purity nitric acid)

Mobile phone/Whatsapp

+86 18926412206

Email

marketing@sinokle.com

Address

Room 2301, Building 1B, Smart Home, Baolong Street, Longgang District, Shenzhen, China

Phone
E-mail
Map
QQ Service